¥ 1495.00
¥ 1495.00
¥ 1495.00
¥ 1495.00
¥ 1495.00
易卖工控网(www.ymgk.com)提供”jancd-fc850-486541模块备件”,产品详情:品牌/厂家:AZOP-005-486936、型号:jancd-fc850-486541、成色:全新、货期:现货 1天内发货、保修:180天,更多产品详情就上易卖工控网。
jancd-fc850-486541
设置此板功能的开关名称以及每个开关的工作方式
开关工程如下所示。确保执行正确的设置
根据以下描述。有关设置的详细信息,请参阅
下一页。
•S1:在DX200上设置此板的站。
车站设置范围为1(ST#01)至D(ST#13)。
无法设置0、E或F。
•SW1:设置传输速率。
在4 Mbps和10 Mbps之间切换。
确保将SW1设置为4 Mbps。无法使用10 Mbps。
如果此板的信息未显示在
编程悬挂式屏幕,尽管通信
电缆和电源电缆按照
第5-1页第5.1节“输入/输出模块设置”,SW1可为
设置为10 Mbps。如果是,请将其更改为4 Mbps。
•SW2:设置输入/输出通信模式。
在17字节或32字节之间切换。
确保将SW2设置为17字节。32字节不能为
习惯于
如果此板的信息未显示在
编程悬挂式屏幕,尽管通信
电缆和电源电缆按照
第5-1页第5.1节“输入/输出模块设置”,SW2可为
设置为32字节。如果是,请将其更改为17字节。
jancd-fc850-486541
jancd-fc850-486541
The names of the switches to set the functions of this board and how each switch works are shown below. Make sure to perform proper settings according to the following description. For details of the settings, refer to the next page. • S1: Sets the station of this board on the DX200. The setting range of the station is 1 (ST#01) to D (ST#13). 0, E, or F cannot be set. • SW1: Sets the transfer rate. Switches between 4 Mbps and 10 Mbps. Make sure to set SW1 to 4 Mbps. 10 Mbps cannot be used. If this board’s information is not displayed on the programming pendant screen although the communication cable and power cable are connected correctly according to section 5.1 “I/O Module Setting” on page 5-1, SW1 may be set to 10 Mbps. If so, change it to 4 Mbps. • SW2: Sets the I/O communication mode. Switches between 17 BYTE or 32 BYTE. Make sure to set SW2 to 17 BYTE. 32 BYTE cannot be used. If this board’s information is not displayed on the programming pendant screen although the communication cable and power cable are connected correctly according to section 5.1 “I/O Module Setting” on page 5-1, SW2 may be set to 32 BYTE. If so, change it to 17 BYTE.